HDMS.QC.PLUS Compendium
These are QC's run by the HDMS.QC.PLUS batch command. If you ran the HDMS.QC.PLUS batch command, you can match up the report results by using the "Listname" column in the tables below. Then click on the QC Name to go directly to the page that describes how to resolve the issue that report is all about.
The QC pages are written as stand-alone documents. Therefore, note that steps 1 and 2 of the QC Procedure section of the specific "QC Name" document have already been done by the batch file, and can be used as a reference to describe how the QC results were obtained. Use the "Listname" to activate the set of records that need attention.
This table is sorted in alphabetical order by Listname for ease of locating the pertinent documentation.
| The shaded rows indicate QC's that will always produce some records on the report--they are designed more for review (you review what the conversion is doing to your data). All other procedures are designed to eliminate the number of records found as problems are resolved. |
| |
Listname |
QC Name |
Fix Notes |
| _____ |
EOR_BAD_CREATE_DATE |
BadCreateDate |
Rerun QC only after configuring the symbolic field (that is, until you are satisfied with the results) |
| _____ |
EOR_BAD_MAPPER |
BadMapper |
Fix data and/or update arev\hdms\ini\custom.cfg configuration in [EO_MAPPER] section; or accept the default action. |
| _____ |
EOR_BAD_TRANSCRIBR |
BadTranscribr |
Fix data and/or update arev\hdms\ini\custom.cfg configuration in [EO_TRANSCRIBR] section; or accept the default action. |
| _____ |
EOR_WSHED_TO_REVIEW |
UnrecognizedWatershedCodes |
Scan report for obvious problems. Note that the procedure for this conversion may not match the QC--follow whatever guidance you receive from your Biotics 4 contact person (this goes in all cases, but this particular QC is somewhat problematic). |
| _____ |
ET_OR_ENR_VALUES |
EtOrExrRankFactors |
Decide where to take them, then update arev\hdms\ini\custom.cfg in [ET_ENR] section; no need to re-run this one. |
| _____ |
ET_OR_ESR_VALUES |
EtOrExrRankFactors |
Decide where to take them, then update arev\hdms\ini\custom.cfg in [ET_ESR] section; no need to re-run this one. |
| _____ |
ET_WITH_SRANKFAILS |
SRankFails |
Correct obvious syntax errors. Failure to resolve this QC leads to extended post-conversion cleanup. Some resolution requires configuring conversion spreadsheets. Please follow the guidelines given by your Biotics 4 Installation Contact person. |
Back to DataQc